Rosewill SATA+Ultra ATA Raid Controller RC212 - Manual (Page 3)

SATA+ Ultra ATA RAID CONTROLLER RC212 User Manual
4
C SATA Connector (Internal)
D SATA Connector (Internal)
E PATA Connector
F Jumpers control BC Switch
G Jumpers control AD Switch
IDE/RAID: Jumper Settings
JP Description
1-2
close Enable SATA Connector B J8-J11
2-3
close Enable SATA Connector C
1-2
close Enable SATA Connector A J12-J15
2-3
close Enable SATA Connector D
Default Mode is all jumper 2-3 close, so C-D is active and A-B is inactive on default.
1.There are four SATA ports in RC212 RAID adapter. We named these ports character A through D. Ports C
to D are internal SATA ports and A to B are external SATA ports.
By changing the jumper setting (F and G) on RC212 that allows you to utilize 2 ports of this card. With
different jumper setting you can active port A, B, C and D .
Hardware Installation
ƒ
Remove the case of the PC system.
ƒ
Remove the inside slot of any available 32-bit PCI slot.
ƒ
Install the VIA VT6421 RAID card in this open slot.
ƒ
Attach hard drives to the VIA VT6421 RAID card.
Create Your Disk Array
You can create your own array using the onboard BIOS utility of the VIA VT6421 card with the