Roland FR-3s - Manual (Page 15)

Attaching the straps
V-Accordion r
15
(2) Connect the small plug of the adapter cable to the
DC IN socket and wind the cable around the guide:
You can also connect the MIDI cable to the MIDI OUT/
IN socket and wind it around the guide like the
adapter cable.
(3) Reinstall the padding, taking care to secure the
adapter cable and/or MIDI cable you have just
installed.
When finished, the FR-3 should look as follows:
(4) Reverse these steps to remove and disconnect the
adapter when you want to stop playing.
Attaching the straps
Proceed as follows to attach the straps to your FR-3:
(1) Unpack the straps.
(2) Put the FR-3 on a stable surface.
The connection panel must face down.
(3) Slide the upper end of one strap through the
holder ring (see the illustration).
The upper end is the part with the velcro portions
and the clip.
(4) Fasten the strap’s upper part to the velcro layer
below it.
(5) Close the security clip to ensure that the strap can-
not come loose.
(6) Repeat steps (3)~(5) for the other strap.
The upper strap ends should look as follows:
(7) Turn the FR-3 around (with the connection panel
on the left side, see below).