Ryobi CSB121 - Manual (Page 20)

20
ACCESSORIES
OPTIONAL RIP GUIDE
Use the optional rip guide, part no. 969862-009, when
making long or wide rip cuts with your saw.
TO ASSEMBLE RIP GUIDE
See Figure 22.
Follow these directions to assemble the rip guide.
■ UNPLUG YOUR CIRCULAR SAW.
WARNING:
Failure to unplug the tool could result in accidental
starting causing serious injury.
■ Place rip guide through holes in base as shown in the
figure.
■ Adjust rip guide to the width needed.
■ Tighten rip guide knob securely.
TO USE RIP GUIDE
Follow these directions to use the rip guide.
■ Secure the workpiece.
■ Position the face of the rip guide firmly against the
edge of workpiece.
■ Guide the saw along the edge to achieve a straight rip
cut.
NOTE: The guiding edge of the workpiece must be
straight for your cut to be straight. Use caution to
prevent the blade from binding in the cut.
OPTIONAL DUST NOZZLE KIT
See Figure 23.
You may purchase a dust nozzle kit, part no. 982829-
001, for use with your saw. As shown in the figure, the
adapter fits over the dust chute which is located on the
upper blade guard.The nozzle attaches to the adapter.
NOTE: If you use the nozzle, you should always connect
it to a standard vacuum hose.
TO ATTACH DUST NOZZLE
Follow these directions to attach the dust nozzle.
■ UNPLUG YOUR CIRCULAR SAW.
WARNING:
Failure to unplug the tool could result in accidental
starting causing serious injury.
■ Lift lower blade guard.
■ Orient adapter to fit into the dust chute opening (1) on
upper blade guard.
■ Secure adapter with screw (2) provided.
■ Align hole in nozzle with raised lip on adapter and
snap into place (3) when using a vacuum hose.
Fig. 22
Fig. 23
RIP GUIDE
RIP GUIDE
SCREW
ADAPTER
RAISED
LIP
SCREW
NOZZLE
HOLE
DUST
CHUTE