Rangemaster 90 INDUCTION U109941 - 02 - Manual (Page 28)

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
26
21. To Replace an Oven Fan
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet and
remove the cover.
Disconnect the three terminals connected to the fan noting
their position. Remove the oven inner back (see 19). Hold the
fan blade and remove the centre nut (left-hand thread) two
brass washers, fan blade and circlip. Unscrew the fan retaining
nuts and washers (three off each) and lift the fan away from
the rear of the cooker. Fit the new fan and reassemble in
reverse order. Check the operation of the oven.
22. To Remove Grill Element
Disconnect from electricity supply.
Remove grill pan from inside the grill compartment; remove
the enamelled front shield from the grill roof, by undoing the
two screws and washers.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element.
Lift the element out carefully, disconnecting the leads from
the element terminals (noting their position). If it is not
possible to disconnect the leads in this way, pull the cooker
forward to gain access to the rear, remove the screws securing
the electric cover to the back sheet, remove the cover and
disconnect the terminals from the rear.
Fit the new element and reassemble in reverse order. Check
the operation of the grill.
23. To Change Oven Light Bulb
Disconnect from electricity supply.
Make sure the oven is cool. Open the oven door and remove
the oven shelves. Remove the grill pan and support from the
grill chamber.
Unscrew the bulb cover by turning anticlockwise. It may be
very stiff (Fig.8-13).
Taking care to protect your fingers in case the bulb should
shatter, unscrew the old bulb.
Fit an Edison screw fitting 15W 240V lamp, FOR OVENS. It must
be a special bulb, heat resistant to 300°C (Fig.8-14).
Screw in the new bulb, and then screw back the bulb cover.
Turn on the electricity supply and check that the bulb now
lights.
ArtNo.324-0007 Unscrewing the bulb cover
Fig.8-13
ArtNo.324-0005 Oven light bulb
Fig.8-14