Raymarine VolvoPenta IPS Autopilot System DPU - Manual (Page 13)

13
unterminated end of the cable is stripped, for connection to the vessel’s RF ground
point.
If you require additional advice on grounding the IPS DPU, please contact the
Raymarine Technical Support Department.
1.12 Connecting to the Volvo Penta system
Volvo Penta Gateway
CAUTION:
Consult your Volvo Penta dealer before making any changes to
your existing system.
Note: To connect to the Volvo Penta system you will need to obtain an Autopilot Interface
kit from Volvo Penta. Part Number 3819744, comprising of a Gateway, Y split, Assembly
instruction and two tie wraps.
Plug the LONG SeaTalk 2 cable into the FIFTH terminal of the 5 way SeaTalk 2
connector block.
Thread the cable into the junction box and connect to the connector block.
Then, thread the bare end of the Raymarine VP interface cable into the junction
box and connect to the connector block. Ensure that the wire colors match.
CAUTION:
Do NOT connect the Raymarine VP interface cable to NMEA2000,
or the system could malfunction.
Connect the other end of the Raymarine VP interface cable (circular connector) to
the connector on the Volvo Penta Gateway.
D7940-2
1
2
CAUTION DO
NOT
CONNECT
TO
NMEA2000 BUS
87054_3.book Page 13 Tuesday, July 18, 2006 8:49 AM