Ryobi HP1442M - Manual (Page 11)

Page 11
20
24
5
OPERATION
WRONG
CHUCK JAWS
DRILL BIT
CHUCK COLLAR
CHUCK BODY
INSTALLING BITS
■ Place the direction of rotation selector in center position.
This will lock the switch trigger in the off position.
See
Figure 4.
■ Open or close the chuck jaws to a point where the opening
is slightly larger than the bit size you intend to use. Also,
raise the front of your drill slightly to keep the bit from
falling out of the chuck jaws.
■ Insert your drill bit into the chuck the full length of the jaws.
See Figure 8.
■ Tighten the chuck jaws on the drill bit. To tighten, grasp
and hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of the arrow
marked GRIP to tighten the chuck jaws.
■ DO NOT use a wrench to tighten or loosen the chuck
jaws.
WARNING:
Do not insert drill bit into chuck jaws and tighten as shown
in figure 9. This could cause drill bit to be thrown from
drill resulting in possible serious personal injury or
damage to the chuck.
REMOVING BITS
See Figure 8.
■ Place the direction of rotation selector in center position.
This will lock the switch trigger in the off position.
See
Figure 4.
■ Loosen the chuck jaws from drill bit .
■ To loosen: grasp and hold the collar of the chuck with one
hand, while rotating chuck body with your other hand.
Note: Rotate chuck body in the direction of the arrow
marked RELEASE to loosen chuck jaws.
■ DO NOT use a wrench to tighten or loosen the chuck
jaws.
■ Remove drill bit from chuck jaws.
MAG TRAY™
See Figure 10.
For convenience, your drill has a Mag Tray™ to place small
parts when doing a variety of tasks.
RIGHT
Fig. 9
MAG TRAY™
(SCREW HOLDER)
Fig. 10
20
24
5
2
5
Fig. 8