Roberts Radio R9958 - Manual (Page 12)

Manual tuning
1. Press the On/Off button to switch on your radio.
2. Select the required waveband by repeatedly pressing the Band but-
ton. For the FM waveband fully extend the wire aerial and position for
optimum reception. For MW reception there is a built in ferrite aerial.
Rotate your radio to the position giving best reception.
3. A single press on either the Tuning up or Tuning down buttons will
change the frequency in the following increments:-
FM 50 or 100kHz
MW 9 or 10 kHz
4. When the waveband end is reached the radio will continue tuning from
the opposite waveband end.
5. Press the Volume up or down buttons to set the required level.
6. To switch off your radio press the On/Off button. The display will show
OFF.
1 2
5 5
6
3 3
11