Ryobi CSB1308 - Manual (Page 15)

Page 15
TO POCKET CUT
See Figure 21.
WARNING:
Always adjust bevel setting to zero before making a
pocket cut. Attempting a pocket cut at any other setting
can result in loss of control of your saw possibly causing
serious injury.
Adjust the bevel setting to zero, set blade to correct blade
depth setting, and swing the lower blade guard up using the
lower blade guard handle. ALWAYS RAISE THE LOWER
BLADE GUARD WITH THE HANDLE TO AVOID SERIOUS
INJURY. While holding lower blade guard by the handle,
firmly rest the front of the base flat against the workpiece
with the rear of the handle raised so the blade does not
touch the work.
See Figure 21. Depress the switch trigger.
ALWAYS LET THE BLADE REACH FULL SPEED, THEN
SLOWLY LOWER BLADE INTO THE WORK UNTIL BASE
IS FLAT AGAINST WORK. After you complete your cut,
release the trigger and allow the blade to come to a complete
stop. After the blade has stopped, remove it from the work.
Then, corners may be cleared out with a hand saw or sabre
saw.
WARNING:
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to serious injury.
WARNING:
Do not use this product as a component of other products.
Also, do not use attachments or accessories not
recommended for use with this product. Any such use
could result in possible serious personal injury.
OPERATION
45
0
Fig. 21
LOWER BLADE
GUARD
POCKET CUT
LOWER BLADE
GUARD HANDLE