Ringdale ISDN - Manual (Page 140)

140
If you chose Enabled for IPX Routing, then the following
additional prompts will appear:
Local IPX Network :
Type in an IPX address of the form _ _ _ _ _ _ _ _, where each _ is a
hexadecimal number between 0 - 9 or A - F. This is your network
address.
Press the Enter key when you are ready to continue.
Then the prompt
IPX Frame Type : Ethernet II
will appear.
The default of IPX Frame Type is Ethernet II.
Pressing the spacebar switches between Ethernet II,802.2, SNAP, and
802.3
If you have a Novell server on your Ethernet network, you must choose
the same frame type as the Novell server uses.
Choices:
• Ethernet II is used for an Ethernet network using the
Ethernet II frame type.
• Ethernet 802.2 is used for an Ethernet network using the
Ethernet 802.2 frame type.
• Ethernet SNAP is used for an Ethernet network using
the Ethernet SNAP frame type.
• Ethernet 802.3 is used for an Ethernet network using the
Ethernet 802.3 frame type.
Press the Enter key when you are ready to continue.
CONFIGURING WITH A LOCAL CONSOLE