Rosewill RC216 - Manual (Page 6)

4
User Manual SATA II / ATA 133 PCIe Card RC216
Mode 3 - Con4 Con3 Active
Mode 4 - Con2 Con3 Active
Note: By default, Con1 and Con2 are working. Con3 and Con4 are deactive.
Hardware Installation
1. Turn Off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCIe slot.
4. To install the bard, carefully align the card’s bus connector with the selected PCIe slot on the
motherboard. Push the board down firmly.
5. Attach your internal or external devices to the PCIe SATA II 300 + PATA Raid Card.
6. Replace the slot bracket’s holding screw to secure the card.
7. Replace the computer cover and reconnect the power cord.
RAID Arrays
RAID Arrays are setup in the PCIe SATA II 300 + PATA Raid Card’s BIOS.
There are four configurations supported:
2 & 3 PIN close 2 & 3 PIN close
Con3 Con4
Con2 Con1
2 & 3 PIN close 1 & 2 PIN close
Con3 Con4
Con2 Con1