Radio Shack ET-546 - Manual (Page 10)

10
• The first time you use your phone
after installing a new battery, the
handset might not work or might
sound an error tone when you
press
TALK . This might also occur
when you recharge a battery that
has been completely discharged.
If this happens, be sure RINGER
ON/OFF is set to ON . Then return
the handset to the cradle for 5
seconds. This resets the security
access code.
• If the CHARGE indicator does not
light when you place the handset
on the cradle, be sure the battery
is connected to the pins inside the
battery compartment, and the AC
adapter is securely connected to
the base.
Also, check the charging contacts
on the handset and base. If the
contacts are dirty or tarnished,
gently clean them with a pencil
eraser.
• About once a month, fully dis-
charge the battery. Keep the
handset off the cradle until BATT
LOW lights. Then return the hand-
set to the cradle and recharge the
battery for about 10 hours.
SETTING THE DIALING
MODE
Set TONE/PULSE on the base for the
type of service you have. If you are not
sure which type you have, do this test.
1. Set TONE/PULSE to TONE.
2. Lift the handset, press TALK , and
listen for a dial tone.
3. Press any number other than 0 .
If the dial tone stops, you have touch-
tone service. Leave
TONE/PULSE set
to TONE .
If the dial tone continues, you have
pulse (rotary) service. Set
TONE/
PULSE to PULSE .
43-1046.fm Page 10 Tuesday, August 17, 1999 11:05 AM