Radio Shack TAD-1028 - Manual (Page 8)

8
When you first connect power, the
PLAY/SKIP indicator flashes rap-
idly (until you record the outgoing
message), the ANSWER indicator
flashes (if you did not install a
backup battery), and the TAD-1028
automatically runs a self-test for
about 10 seconds. You cannot
operate the TAD during this test.
When the test is complete, the
TAD-1028 beeps once and
announces, “Answer off.”
On a Wall Plate
1. Plug one end of the supplied short
modular cord into the TO LINE jack
on the back of the base.
2. Route the cord into the groove on
the phone’s base.
3. Plug one end of the supplied coiled
cord into the jack on the bottom of
the base and route the cord into the
groove beside the jack.
4. Insert the supplied AC adapter’s
barrel plug into the AC 9V 440mA
jack on the back of the base.
5. Plug the other end of the short
modular cord into the wall plate
jack. Then, with the power cord
hanging to the right of the two tabs,
align the wall plate studs with the
TAD’s keyhole slots and slide the
TAD downward to secure it.
Illus. of ANSWER and
PLAY/SKIP indicators.
Illus. like in Step 1
under “On a Desk Top”
Illus. showing routing
of modular cord.
Illus. showing routing
of coiled cord before
it is plugged into the
handset.
Illus. of AC 9V 440mA
jack. Show barrel
inserted into jack.
plug about to be
Show modular cord
already connected.
43-788.fm Page 8 Monday, August 16, 1999 8:19 AM