Ricoh G700SE - Manual (Page 36)


Registering Barcode Data as a
Temporary Memo
The camera can read barcodes and store the
data as temporary descriptions for temporary
memos. Barcodes can be read in both shooting
and playback mode.
• The camera can read linear barcodes of up to
32 digits and matrix barcodes of up to 2400
digits. The barcode type can be selected using
the [Barcode Type] option in the camera memo
menu.
• Voice memos are not available with matrix
barcodes. The [Record] option is not displayed
in the description list when a matrix barcode
type is selected.
Choosing a Barcode Mode
The [Barcode Mode] option in the camera
memo menu can be used to choose where
barcode data are stored.
Mode1 The barcode is stored in the memo list as
a temporary description for the first item.
This description is overwritten each time a
barcode is read.
Mode2 The first barcode read is stored in the memo
list as a temporary description for the first
item, the second barcode as a temporary
description for the second item, the third
barcode as a temporary description for
the third item, and the fourth barcode as a
temporary description for the fourth item.
These descriptions are overwritten in turn as
new barcodes are read.
Mode3 This option only takes effect in shooting
mode. Up to fifty barcodes can be stored in
the memo list as temporary descriptions for
the first item. These data can be viewed in
the camera memo dialog before shooting but
can not be changed and are deleted after a
photograph is taken.
Reading a Barcode and Registering
Barcode Data
Shooting Mode
1.
Press the ADJ./MEMO button.
The [Camera Memo] screen appears.
2.
Point the camera toward the
barcode you want to read and press
the # button.
The camera switches to macro mode and
reads the barcode data. When the camera
finishes reading the barcode, the data are
stored as a temporary description for the
first item in the memo.
1234567890
Foundation work
Exterior
Beverly Beech
Gamma Company
Barcode
Const.type
Location
Supervisor
Affiliates
FileName/SAMPLE
Camera Memo 1/45
FILE LIST Memo On
If the camera is unable to read the barcode
or if you wish to exit without reading the
barcode, press $ or DISP. to return to the
camera memo dialog. Press # to read the
barcode again.
Non-ASCII characters in the barcode data
will be replaced by asterisks (“*”).
3.
Read additional barcodes.
If [Mode2] or [Mode3] is selected for
[Barcode Mode], repeat Step 2 to read
additional barcodes.