Ryobi HP722 - Manual (Page 6)

Page 6
FEATURES
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
WARNING:
Carefully read through this entire operator's manual before
using your new drill-driver. Pay close attention to the Rules
For Safe Operation, Warnings and Cautions. If you use your
drill-driver properly and only for what it is intended, you will
enjoy years of safe, reliable service.
WARNING:
Do not allow familiarity with your drill-driver to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
KEYLESS CHUCK
Your drill-driver has a keyless chuck that allows you to hand
tighten or release drill bit in the chuck jaws.
PRODUCT SPECIFICATIONS:
DRILL-DRIVER HP62 HP722
Chuck 3/8 in. Keyless 3/8 in. Keyless
Motor DC Motor 6.0 Volt DC Motor 7.2 Volt
Switch Two Speed Two Speed
No Load Speed 300 - 500 RPM 330 - 500 RPM
Clutch 24 Positions 24 Positions
Charger Input 120 V, 60 Hz, AC only 120 V, 60 Hz, AC only
Charge Rate 3-6 Hours 3-6 Hours
SWITCH
To turn your drill-driver ON, depress the switch trigger.
Release switch trigger to turn your drill-driver OFF.
SWITCH LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
TWO SPEED SWITCH
Your drill has a two speed feature in the switch. Depress the
switch trigger halfway for driving screws at a low speed.
Depress the switch trigger all the way for normal drilling.
FORWARD/REVERSE SELECTOR
(DIRECTION OF ROTATION SELECTOR)
Your drill-driver has a forward/reverse selector located above
the switch trigger.
BIT STORAGE
When not in use, bits provided with your drill-driver can be
placed in the storage area located on the top of the motor
housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the top end of the motor housing.