Radio Shack 43-3535 - Manual (Page 14)

14
Installation
— When you first use the phone
after charging or recharging the
battery pack
— If the battery pack is completely
discharged
— If the base loses power for
about an hour while the handset
is away from it
While holding PAGE , return the
handset to the base for about 3
seconds to reset the security
access-protection code.
• If the battery pack becomes weak
during a call, the handset beeps
every 3 seconds and
Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho
flashes. When this happens, you
cannot make a call until you
recharge the battery pack.
• If the display is blank and the
phone does not work, recharge the
battery pack. (The battery power
might be too low to light the
display.)
• About once a month, fully
discharge the battery by keeping
the handset off the base until
Bemý Bemý Bemý Bemý
8Wjj[ho 8Wjj[ho 8Wjj[ho 8Wjj[ho
flashes on the display.
Otherwise, the battery pack loses
its ability to fully recharge.