Roland MC-909 - Manual (Page 110)

110
How Things Work (in Sampling mode)
fig.0-01
In the Sampling section of the panel, press [SAMPLING/
RESAMPLING] so the indicator is lighted. The Sampling Menu
screen will appear.
During sampling, the panel controls have the following functions.
1. D Beam controllers
Pass your hand over these to modify the pattern (p. 35).
2. Volume section
3. Realtime Modify section
These controls modify the sound (p. 33).
4. Mastering section
5. Velocity pads
Use these pads as a keyboard to play sounds or trigger phrases (p.
27).
6. Function buttons
These buttons access the function screens indicated in the bottom
line of the display.
1
2
3
4
5
6
7
8
9
12
13
14
10
11
[BEAM 1 ON] Turns the left D Beam controller
(BEAM 1) on/off.
[BEAM 2 ON] Turns the right D Beam controller
(BEAM 2) on/off.
[D BEAM ASSIGN] Selects the function of the D Beam
controller.
[OUTPUT] Adjusts the output volume of the entire MC-909.
[INPUT] Adjusts the input volume from the INPUT jacks.
[ON] Switches the mastering effect (compressor) on/off.
[BAND] Selects the frequency band to adjust.
[ATTACK] Adjusts the attack time of the input sound.
[RELEASE] Adjusts the time from when the volume falls below
the threshold level until the effect disappears.
MC-909_Ref_e.book 110 ページ ２００５年３月１日 火曜日 午後３時２９分