Rosewill RC-209 User Manual
Page 13
User Manual
SATA 4 Port PCI Adaptor with RAID RC209
Auto configuration (recommended)
The default chunk size is
64k when selecting Auto configuration.
. As the BIOS boots press
Ctrl+S or F4 when prompted to enter the RAID BIOS.
2. At the next screen select
Create RAID Set, then press Enter.
3. Select
RAID10, then press Enter.
4. Select Auto configuration, then press
Enter.
5. Input the RAID size, press
Enter.
6. When asked
Are You Sure(Y/N)?, press Y to accept.
7. Press
Ctrl+E to exit the BIOS.
8. When asked
Are you sure to exit(Y/N)?, press Y to exit and reboot.
9. Continue with FDISK and FORMAT steps as if you were installing a conventional hard drive.
Manual configuration
. As the BIOS boots press
Ctrl+S or F4 when prompted to enter the RAID BIOS.
2. At the next screen select
Create RAID Set, then press Enter.
3. Select
RAID10, then press Enter.
4. Select the number of drives then press
Enter.
5. Select
Manual configuration then press Enter.
6. Select chunk size from
8k, 16k, 32k, 64k or 128k, then press Enter.
7. Select the
first drive, press Enter.
8. Select the
second drive, press Enter.
9. Select the
third drive, press Enter.
0. Select the
fourth drive, press Enter.
. Select
Create without data copy then press Enter.
2. Input the RAID size, press
Enter.
3. When asked
Are You Sure(Y/N)?, press Y to accept.
4. Press
Ctrl+E to exit the BIOS.
5. When asked
Are you sure to exit(Y/N)?, press Y to exit and reboot.
6. Continue with FDISK and FORMAT steps as if you were installing a conventional hard drive.
RAID 5 (Parity)
This RAID array to be used on
New/Blank hard drives. Striping will destroy existing data on the
hard drive.
Auto Configuration is recommended. For applications that require custom chunk
size,
Manual Configuration is offered.
Auto configuration (recommended)
The default chunk size is
64k when selecting Auto configuration.
. As the BIOS boots press
Ctrl+S or F4 when prompted to enter the RAID BIOS
2. At the next screen select
Create RAID Set, then press Enter.