Raymarine ST6002 - Manual (Page 13)

Chapter 1: SmartPilot Operation 3
When the power supply is switched off, the SmartPilot controller buttons have no
effect.
Notes: (1) Each time power to the SmartPilot controller is switched on, the control-
ler is initially in the on condition. You do not need to use the disp
button to switch the controller on.
(2) When the SmartPilot controller is on, the operation of the disp button
will perform other operating functions, as described below.
Start-up mode
The SmartPilot always powers up in Standby mode with the display showing the
boat’s current compass heading.
Note: You can press standby at any time to return to manual steering.
Keypad functions
The SmartPilot is controlled using simple push-button operations, all of which are
confirmed with a short beep. In addition to the main single-button functions,
there are several dual-button operations.
TRACK
Press for Track
mode from Auto
(if a navigator is
connected)
Press to accept
waypoint advance
Press for 1 second
to skip waypoint
AUTO
Press for Auto mode
DISP
STANDBY
Press for
Standby mode
Press for 2 seconds
to enter Calibration mode
Course change keys
Port 1˚ Starboard 1˚
Port 10˚ Starboard 10˚
STANDBY plus AUTO
Press for Wind Vane mode
(if a wind vane is connected)
-1 plus +1
Press for Response level
Press for 1 second
for Rudder Gain
+1 plus +10
Press together
for AutoTack
to starboard -1 plus -10
D5449-3
Press to display data
pages
When powered down, press
for 1 second to power up
Press for 9 seconds (in
Standby mode) for power
down
Press for 1 second for
lamp adjust
Press for 3 seconds for
contrast adjust
Press together for
AutoTack to port
81269_1.book Page 3 Wednesday, November 9, 2005 2:35 PM