Ricoh H5676 - Manual (Page 80)

Delivering Scan Files
72
3
Preparation for Delivering
This section explains the preparation and settings for delivering scan files.
Important
❒ This function is available only when Function Upgrade Option is installed.
❒ The network delivery scanner requires a delivery server that has software
such as the optional ScanRouter delivery software installed. For details about
the ScanRouter delivery software, see the manuals supplied with the Scan-
Router delivery software.
❒ To view files delivered to an in-tray, you must install DeskTopBinder on the
client computer.
A
Connect the machine to the network.
Connect the machine to the network using an Ethernet cable or IEEE 1394 ca-
ble, or wireless LAN (IEEE 802.11b).
B
Make the necessary settings in [System Settings].
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine’s IPv4 address and subnet mask.
• In [Effective Protocol], enable [IPv4].
• Set [Delivery Option] to [On].
C
If necessary, change settings in [Send Settings] under [Scanner Features].
D
Using the ScanRouter delivery software, register this machine as an I/O de-
vice. In addition, register destinations and specify such settings as the de-
livery type and sender.
For details, see the ScanRouter delivery software manuals.
Note
❒ To connect the machine to the network using an IEEE 1394 cable or wire-
less LAN (IEEE 802.11b), an extended 1394 board or extended wireless
LAN board is required respectively. For details, see Network Guide.
❒ Items to set up in [System Settings] vary depending on the network environ-
ment. For more information about network settings, see General Settings
Guide.
❒ For details about installing DeskTopBinder Lite, see “Installing DeskTop-
Binder Lite from Provided CD-ROM”.
Reference
p.73 “Installing DeskTopBinder Lite from Provided CD-ROM”