Roberts Radio WiFi Internet Radio WM-202 - Manual (Page 56)

55
Automatically updating the clock
Your radio will normally update the clock automatically when connected to
the internet. If you enter a time setting manually, the radio will calculate a
local time offset so that whenever it synchronises using the internet, the
correct local time is stored in the radio. In the event of a power failure,
your radio will connect to the internet and then set the clock automatically
based on this information.
You may wish to use the radio away from the internet, in which case you
may specify that the radio sets its clock from the time information in DAB
radio broadcasts. After a power failure the radio will set its clock the next
time that you turn on the radio in DAB mode.
Alternatively you may specify that the time is not automatically updated.
In this case the clock must always be set manually after a power
interruption
1. Access the main menu by pressing the Menu button until the 'Main menu'
option is shown, then select this with the Tuning/Select control.
2. Rotate the Tuning/Select control until 'System setup' is highlighted
on the display. Press the control to enter the system setup menu.
3. Rotate the Tuning/Select control until 'Time setup' is highlighted on
the display. Press the control to enter the time setup.
4. Rotate the Tuning/Select control until 'Auto update' is highlighted
on the display. Press the control to enter the auto-update selection
menu.
5. Rotate the Tuning/Select control to select from 'Update from NET',
'Update from DAB' or 'No update' as required. Press the control to
confirm you choice. The radio will then exit to the previous menu
display.
1-5
1
>Update from NE*
Update from DAB
No update
Update from NET
>Update from DA*
No update
WM-202 iss 1.indd 56 20/02/2008 13:04:08