Rosewill WIRELESS N ADAPTER RNX-N150UBE User Manual
Page 25
Wireless N Adapter
RNX-N150UBE User Manual
If there is more than one AP on the PBC mode, there will be session overlap. Please
using method 1 PIN Input Config(PIN) or wait for a while push the button again.
FAQ
This chapter provides solutions to problems that may occur during the installation
and operation of the Wireless USB Adapter. Read the descriptions below to solve your
problems.
1. The Wireless USB Adapter does not work properly.
Reinsert the Wireless USB Adapter into your PC’s USB slot. Right click My
Computer and select Properties. Select the device manager and click on the
Network Adapter. You will find the Adapter if it is installed successfully. If you see
the yellow exclamation mark, the resources are conflicting. You will see the
status of the Adapter. If there is a yellow question mark, please check the
following:
Make sure that you have inserted the right adapter and installed the proper driver.
If the Adapter does not function after attempting the above steps, remove the
adapter and do the following:
Uninstall the driver software from your PC through Control Panel’s “Add or
Remove Programs”.
Restart your PC and repeat the hardware and software installation as specified in
this User Guide.
2.
I cannot communicate with the other computers linked via Ethernet
in the Infrastructure configuration.
Make sure that the PC to which the Adapter is associated is powered on.
Make sure that your Adapter is configured on the same channel and with the
same security options as with the other computers in the Infrastructure
25