ROTEL RHB-200 - Manual (Page 13)

13
To make the only additional device but-
ton, put SW5 in the ON position:
To make the only additional device
button, put SW6 in the ON position:
To make both and additional de-
vice buttons, put both SW5 and SW6 in the
ON position:
For no additional device buttons, put both
SW5 and SW6 in the OFF position:
Learning commands
The RKP-200 keypad is programmed at the factory
with basic commands for Rotel and other compo-
nents as described in the Operating the Keypads
section of the manual. These commands can be
replaced when using non-Rotel components or for
access to different features.
New commands are learned by the keypad by
using a learning procedure during initial configu-
ration of the keypad involving aiming the hand-
held remote for the component at the IR sensor
on the keypad.
The four device buttons ( ,
, , ) can-
not be used to learn commands. In addition, you
should not learn new commands replacing the ,
, , and commands. Therefore, there
are six buttons available for learning. These but-
tons can store commands for each of the devices,
ten commands for the device, ten for the
device, etc. Overwriting commands for a device
will not change the existing commands for any of
the other devices.
If you have designated and/or as device
buttons (SW5 and/or SW6 in the ON position),
these buttons cannot be used to learn commands.
However, they can be used as device buttons with
commands learned on other buttons, just like the
four standard device buttons ( , , , ).
In addition to learning commands on standard but-
tons, each of the four main device buttons ( , ,
, ) can store 14 invisible layer commands.
These commands cannot be used during normal
system operation from the keypad; however, they
can be used as part of Smart Macro sequences.
The procedure for learning these invisible layer
commands is described in the next section.
In this example of learning standard commands,
we will change the command for the button
for the device to a PAUSE command instead of
the original NEXT DISC command. To learn the
new command:
1. The
button lighting flashes to confirm suc-
cessful or failed learning. So, the backlighting
feature must be active before starting the learn-
ing procedure (SW10 in the ON position).
Also, the IR sensor must be enabled (SW9 in
the ON position). Confirm the position of SW9
and SW10:
2. Press the device key containing the commands
(the button in this example).
3. Put the keypad into Learning mode by moving
SW7 to the ON position:
4. Within 30 seconds, press the keypad command
button that you wish to learn (in this example,
the button). The backlighting on the
button turns on and the keypad is ready
to receive the IR code. It will flash six times if
an improper button is pressed (for example,
a device button that cannot be learned).