Roland MC-09 - Manual (Page 44)

44
Applying an effect
Changing the effect type
Each effect provides several variations, which allow it to be controlled by
the step sequencer or by external synchronization. These are called
effect
types . You can select the effect type that is most suitable for your
performance situation.
Smoothing : When using the step sequencer to control the effect (p.
45), this creates smooth changes between each step.
Synchronization : The rate of the filter, phaser, or slicer will be
synchronized to the standard tempo. Use the C1 knob to
choose the note value for synchronization (16th note, 8th
note, quarter note, half note, whole note, whole note x2,
whole note x4).
Effect type Parameters that
can be controlled Smoothing Synchroni-
zation
Filter
Cutoff frequency On —
Cutoff frequency Off —
Resonance On ❍
Resonance Off ❍
— — ❍
Resonance On —
Resonance Off —
— — —
Isolator
Low gain On —
Low gain Off —
Middle gain On —
Middle gain Off —
High gain On —
High gain Off —
— — —
Phaser
Modulation depth On —
Modulation depth Off —
Resonance On ❍
Resonance Off ❍
— — ❍
Resonance On —
Resonance Off —
— — —
Slicer
Slice level Off —
Pan On ❍
Pan Off ❍
— — ❍
Pan On —
Pan Off —
— — —
If you want only Pan to
change for S-5, S-6, or S-7,
turn the C1 knob all the
way to the left. If you want
only resonance to change
for F-6, F-7, or F-8, turn the
C1 knob all the way to the
left.