Remington 489 - Manual (Page 21)

Troubleshooting Guide (cont.)
19
Dirt build-up on breech not
allowing proper penetration
of firing pin. Check firing pin indentation
on cartridge. Clean breech,
breech face, sear and firing
pin. Replace worn or dam-
aged parts.
Inspect and clean complete
tool. Replace worn or dam-
aged parts. Lack of proper cleaning.
Tool does not fire.
Opening and clos-
ing of barrel or
pushing down on
the tool, etc. is not
smooth but is
rough or binds.
PROBLEM POSSIBLE CAUSE REMEDY
482-80
Wood or Non-Metals
To Concrete
Fasteners
Fasten wood or non-metals to concrete or steel.
482-79
Wood or Non-Metals
To Steel
482-78
SP FASTENERS
IMPORTANT
This tool is designed to use 22 caliber necked-down crimped
loads, power levels 1 (gray) through 4 (yellow).
5/8"
Straight Wadded
Load
Necked-Down
Crimped Load
G 018
WARNING ICON G 001
CAUTION
Do not use any load other than the 22 caliber necked-
down crimped load. Other types of loads will cause load-
ejection problems.