Remote control, Install remote battery, Remote sensor – RCA Pro884HB User Manual

Page 13

Advertising
background image

PUSH

REW

F.FWD

STOP

PLAY

A/V DUB

PAUSE

DISPLAY

RESET

TITLE

RECORD

T

W

ZOOM

ON

OFF

S.EDIT

The remote operates the camcorder by
infrared light, so it is protected from
electrical and sound interference.

However, the remote must be aimed
directly at the camcorder’s remote
sensor. There cannot be any obstructions
between them.

Note: The camcorder may not respond to the
remote control if the camcorder’s remote
sensor is exposed to direct sunlight or strong
artificial light.

Remote Sensor

11

Remote Control

1. Turn remote over, insert a pin or

straightened paper clip in the pin hole,
and remove the battery holder.

2. Insert battery so positive (+) terminal

faces up.

3. Replace battery holder.

Notes: Never place anything heavy on top of
the remote control or lay it upside-down.

Replace battery when camcorder fails to
respond to remote.

Remove the battery from the remote if it will
not be used for a month or more. This will
prevent possible damage from battery
leakage. If leakage occurs, wipe up the liquid
inside the compartment and replace
the battery.

Install Remote Battery

Back of Remote

Battery Holder

Pin Hole

Cautions: Lithium cell battery. Must be
disposed of properly. Never handle a
punctured or leaking cell. May cause burns
or personal injury.

Keep out of the hands of children. Can
cause death or injury if swallowed. If
swallowed, consult a physician immediately
for emergency treatment.

The lithium cell used in this device may
explode resulting in a fire or chemical burn if
mistreated. Do not recharge, disassemble,
heat above 212˚F (100˚C), or incinerate.

Never use metallic tweezers to hold the cell,
and never short circuit the + and – sides of
the cell.

Advertising