Rosewill RNX-N150PCX - Manual (Page 30)

Wireless N Adapter RNX-N150PCx User Manual
Rescan: Click to rescan the wireless networks.
Information: Display the information about WPS IE on the
selected network. List information includes Authentication
Type, Encryption Type, Config Methods, Device Password
ID, Selected Registrar, State, Version, AP Setup Locked,
UUID-E and RF Bands.
PIN Code: 8-digit numbers. It is required to enter PIN Code into
Registrar using PIN method. Each Network card has only
one PIN Code of Enrollee.
Config Mode: Enrollee or an external Registrar.
Table of Credentials: Display all of credentials got from the
Registrar. List information includes SSID, MAC Address,
Authentication and Encryption Type. If STA Enrollee,
credentials are created as soon as each WPS success. If
STA Registrar, RaUI creates a new credential with
WPA2-PSK/AES/64Hex-Key and doesn't change until next
switching to STA Registrar.
Detail: Information about Security and Key in the credential.
Connect: Command to connect to the selected network inside
credentials.
Rotate: Command connect to the next network inside credentials
Disconnect: Stop WPS action and disconnect this active link.
And then select the last profile at the Profile Page of RaUI if
exist. If there is an empty profile page, the driver will select
any non-secure AP
Delete: Delete an existing credential. And then select the next
credential if exist. If there is an empty credential, the driver
will select any non-security AP.
PIN: Start to add to Registrar using PIN configuration method
PBC: Start to add to AP using PBC configuration method.
WPS associate IE: Send the association request with WPS IE
during WPS setup. It is optional for STA.
WPS probe IE: Send the probe request with WPS IE during
WPS setup. It is optional for STA.
Progress Bar: Display rate of progress from Start to Connected
status
Status Bar: Display currently WPS Status
Note: When you click PIN or PBC, please don't do
any rescan within two-minute connection. If you want to abort
this setup within the interval, restart PIN/PBC or press
Disconnect to stop WPS action.
- 30 -