RCA TruFlat 20F500TDV - Manual (Page 42)

42
LINE 1 IN VIDEO
AUDIO L(MONO)
R
VIDEO
AUDIO L
R
OUT PUT
DIGITAL AUDIO
VHF/UHF
COAXIAL
If you connect the unit to another VCR or camcorder, you can duplicate a previously recorded tape.
Make all connections before turning on the power.
Duplicating a video tape
Load a blank cassette tape with the erase preven-
tion tab intact into the recording unit.
Load a previously recorded tape into the playback
VCR or CAMCORDER.
1
Press SPEED to select the desired tape speed SP
or SLP.
It is recommended that you set the speed to the
SP mode on the recording unit for best results.
2
Press INPUT SELECT to select AUDIO/VIDEO
input position. "LINE 1" or "LINE 2" will appear on
the screen.
3
Press REC/OTR on the recording unit, then press
PAUSE/STILL.
4
Press the PLAY button on the playback VCR or
CAMCORDER, then press the PAUSE/STILL
button.
5
Release the recording pause and the playback still
simultaneously to begin the duplicating process.
6
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer’s
instructions. A typical camcorder dubbing hookup
is shown above.
To AUDIO (L) OUT
AUDIO/VIDEO
Cord (not supplied)
Playback VCR
To VIDEO OUT To AUDIO (R) OUT
AUDIO/VIDEO Cord (not supplied)
To AUDIO (R) IN
To AUDIO (L) IN
To VIDEO IN
Recording unit
To AV Jack
Playback Camcorder
Connection with second Video recorder Connection with Video camera
Duplicating a video tape
LINE1: on the rear panel
LINE2: on the front panel
Recording unit
To AUDIO (L) IN
To VIDEO IN
To AUDIO (R) IN