Using dual watch replacing the fuse – Radio Shack TRC521 CB User Manual

Page 11

Advertising
background image

11

To silence the alert tones, press

ALERT TONE OFF

.

WX/ALERT

flashes until you switch to WX mode and listen to

the broadcast. Or press

PTT

to silence the alert tones so

WX/ALERT

stops flashing.

Ô

To reduce the alert tone levels for subsequent alerts, hold
down

ALERT TONE OFF

for about two seconds while

WX/ALERT

flashes. The tone stops and

WX/ALERT

flashes

slowly. If the radio receives a new weather alert, three
low-level, short beeps sound (regardless of alert type).

To listen to the weather when an alert is received, slide

CB/WX

to

WX

.

WX/ALERT

turns off.

U

SING

D

UAL

W

ATCH

You can set your radio to constantly monitor for emergency
(Channel 9) signals. If an emergency signal is received, the
CB radio automatically tunes to Channel 9 so you can hear
the broadcast. When finished, the radio returns to the
previous station. This feature only works in CB mode.

To activate dual watch, press

DUAL WATCH

.

DUAL WATCH

lights. Press

DUAL WATCH

again to deactivate.

R

EPLACING

THE

F

USE

The CB’s in-line fuse protects it from power surges and
short circuits. When replacement is required, use a 2-amp,
fast-acting glass fuse, available at your local RadioShack
store.

1. Make sure the vehicle and CB are turned off.

2. Hold the fuse holder at both ends, push the ends

together, twist one end counterclockwise, and pull them
apart.

3. Remove the old fuse and inspect its condition. If it is

blown, insert a new one of the same type and rating. If
it is not blown, reinsert it.



4. Push the fuse holder ends together and twist one end

clockwise.

Ô

NOTE

Ô

You cannot transmit while
WX/ALERT flashes in CB mode.

Fuse

Fuse Holders



CAUTION



Do not use a fuse with ratings
other than those specified here.
Doing so will make your CB
susceptible to electrical damage.

Advertising