User maintenance, Disposal – Remington Men's Shaver User Manual

Page 5

Advertising
background image

9

User Maintenance

The hand-held unit shall be detached

from the power supply cord before

cleaning. The shaver shall not be

used until it has dried.

Replacing the Shaving Head

Cartridge:

When your shaver’s cartridge replace-

ment indicator begins to flash, it is

time to replace the shaving head.

The replacement part is model HGX-

RC1(1-pack) or HGX-RC2(2-pack).
In order to change the shaving head

cartridge, simply push the eject button

on the shaver and the cartridge will

eject from the shaver. If a cartridge is

ejected before the indicator light flash-

es, the cartridge can be placed back

onto the shaver until the hair pocket

becomes full. When a new cartridge is

installed, the replace indicator light will

flash, confirming the beard-type set-

ting (3 flashes for heavy, 2 flashes for

medium, 1 flash for light). The beard-

type selector switch can be changed

at any time up to the third shave, per

cartridge. After the third shave, the

selector switch will be locked until a

new cartridge is installed.
Typically, a shaver with a medium beard

type selected will take approximately 30

shaves to fill the hair collection cham-

ber. The shaver will count a full shave if

the shaver is on for at least one minute

or more. The total number of shaves for

each replacement cartridge will depend

on what beard-type is selected (light,

medium, or heavy).
Replacement Cartridge is model

HGX-RC1(1-pack) or HGX-RC2

(2-pack).
To order shaver accessories call

800.736.4648, Visit

www.remington-products.com

or visit your local retailer.

8

How to Remove the Rechargeable

Batteries:
1.
Unplug the shaver.
2. Run the shaver until the motor

stops.

3. Remove the shaving head

cartridge.

4. Remove screws with a screw

driver.

5. Remove screws holding housing

together.

6. Pull the insert frame out of the

casing.

7. Cut or break the wire straps on

both ends of the batteries, pry the

batteries from the foam adhesive

tape on the Circuit Board.

8. Dispose of batteries properly.

Disposal

Rechargeable Battery

Removal

When your rechargeable shaver

reaches the end of its useful life, the

batteries must be removed from the

shaver and be recycled or disposed

of properly in accordance with your

state and local requirements. If this

is not required by law, you may elect

to dispose of the shaver without the

batteries.

CAUTION! Do not put in fire or muti-

late your batteries when disposing

as they may burst and release toxic

materials. Do not short circuit as it

may cause burns. Dispose of prop-

erly in accordance with your local

and state requirements.

Shaving Tips:

Ensure your skin is dry and free of

oils.

Always hold the shaver at a right

angle to the skin so that the foils are

touching the skin with equal pressure.

Use moderate to slow, circular

stroking movement.

The use of short, circular motions in

stubborn areas may obtain a closer

shave, especially along the neck

and chin line.

Do not press hard against the skin in

order to avoid damage to the foils.

Do not hold the shaver at an angle

in which only one foil is touching the

skin- this will distort the foil and may

cause the cutters to damage the foil.

34768_HGX-1_IB_update.indd 8-9

8/30/07 12:02:21 PM

Advertising