Raymarine GPS navigation - Manual (Page 39)

3.6.5.1 Selecting Waypoints
To control the positioning of the list contents, the
1
(up) key lets you look at the listed waypoints at
the top of the list; the (down) key lets you look
at waypoints down the list. The
.
W 71’ 16. 34
in the highlighted block is the “selected”
and is the that can be operated
on if the keys are pressed.
3.6.5.2 Editing Waypoints
I
To add a name or symbol, or edit the L/L coordinate data to any selected
waypoint, just select-the using either method listed above. When
the memory is highlighted, press the key. This returns you to the
NAME WAYPOMT
display so you can make the necessary changes. To Copy,
Erase, or Protect a particular or event mark just select the
using either method listed above. Press the and the display changes
to WAYPOINT-SF.
3.6.5.3 SF Operations
If you press the key on the List display, you can perform
some additional operations with the stored data including the
following:
A. Protecting Waypoints
While on the List, place the number of
the to be “Protected” in the highlighted
box on the List. Press the
On the SF screen that number
shown under
PROTECTWPTSEVENTS
is correct.
Press the to
turn “ON” the Protection feature.
ON
When a memory is “Protected” the character is displayed on
the LIST and Directory screens, and the may
not be overwritten with new coordinate data until the protection is first turned
OFF or if a “Master Reset” of the unit is performed.
B. Erasing a
While on the List, place the number to be “erased”
in the highlighted box. Then press the
q
softkey for the
SF
menu.
OPERATION 3-25