Ryobi TS1301 - Manual (Page 20)

Page 20
1
2
3
4
5
6
7
8
CUTTING WARPED MATERIAL
See Figures 27 and 28.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 27.
If the warped material is positioned the wrong way as shown
in figure 28, it will pinch the blade near the completion of the
cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 29.
When cutting wide workpieces that are too wide to be
clamped with a work clamp, a C-clamp must be used. For
example, when cutting 2 in. x 6 in. boards, they should be
clamped with a C-clamp as shown in figure 29.
OPERATION
Fig. 27
Fig. 28
Fig. 29
RIGHT
WRONG
WIDE
BOARD
C-CLAMP
22.5 15
31 .6 30
15
31.6
4 5 4 55
22.5 15
31 .6 30
15
31.6
4 5 4 55