Renesas Emulation Pod M30100T3-RPD-E - Manual (Page 6)

( 6 / 52 )
Terminology
Some specific words used in this user's manual are defined as follows:
Emulator system
This means an emulator system built around the PC4701 emulator. The PC4701 emulator system is
configured with an emulator main unit, emulation pod, pod probe, host machine and emulator debugger.
Emulator main unit (Hereafter PC4701)
This means a generic name for emulators for 8 and 16-bit MCUs. For details on specific models of
PC4701, visit the Renesas Tools Homepage at http://www.renesas.com/en/tools
This product does not support the PC4701L and PC4700L.
Emulation pod
This means the M30100T3-RPD-E (this product). This emulation pod is for the M16C/10 Series MCUs.
Pod probe
This means pod probe M301xxT-PRB for the M16C/10 Series MCUs ("x" denotes a number).
Emulator debugger
This means a software tool for M16C/60, M16C/30, M16C/Tiny, M16C/20 and M16C/10 Series
MCUs. The M3T-PD30 controls the emulator from the host machine through various interfaces.
Host machine
This means a personal computer used to control the emulator and emulation pod.
Firmware
Program that analyzes contents of communication with the emulator debugger and controls the
emulator hardware. This program is installed in the EEPROM. This program is downloadable from
the emulator debugger to upgrade the firmware or to support other MCUs.
Target MCU
This means the microcomputer you are going to debug.
Target system
This means a user's application system using the microcomputer to be debugged.
Evaluation MCU
This means the microcomputer mounted on the pod probe which is operated in the specific mode for
tools.
*
In this user's manual, this symbol is used to show active Low. (e.g. RESET*: Reset signal)