RCA Plus+ VR702HF - Manual (Page 68)

66
Appendix: reference
Front Panel Diagram
AUDIO (LEFT MONO, RIGHT) and VIDEO INPUT Jacks Receives signals from another
component, such as a VCR or camcorder, when connected through these jacks. to record from
these jacks, use the INPUT button on the remote control to select L2.
CHANNEL TRACKING Up/Down Selects next higher or lower channel in the VCR’s channel
memory. When a tape is playing, these buttons adjust tracking. Press both buttons at the same
time to recenter tracking.
FWD Forwards the tape when the VCR is stopped. Searches the picture forward during
playback. Starts slow motion during play-pause and increases slow-motion speed.
INPUT Toggles between the VCR’s video input channel and regular antenna/satellite
connections. To view the broadcast from an external device (such as a camcorder) connected
to the VCR’s audio/video jacks, tune to the VCR’s Video Line Input.
PLAY/PAUSE Plays a tape. Pauses action for viewing during playback. Pauses recording to
prevent recording of unwanted scenes.
POWER Turns the VCR on or off. The power button glows at all times, even when the VCR is
turned off.
RECORD Starts VCR recording. Also used for Express Recording (XPR).
Remote Sensor Receives signals from the remote control. Aim the remote at this sensor.
REV Rewinds the tape when the VCR is stopped. Searches the picture in reverse during
playback. Starts slow motion during play-pause and decreases slow-motion speed.
STOP•EJECT Stops normal VCR functions such as record, playback, rewind, fast-forward, and
pause. Ejects the tape when the VCR is stopped.
TAPE SPEED Selects a recording speed (either SP or SLP).
TV•VCR Switches the picture signal so that it either comes from the VCR or the cable/
antenna system.
POWER
TAPE SPEED
INPUT
TV•VCR
VIDEO
INPUT LEFTMONO RIGHT
VIDEO
PLAY
PAUSE
REV FWD
STOP•EJECT RECORD
CHANNEL
TRACKING
Remote Sensor