Warning, Save these instructions, Ryobi technologies, inc – Ryobi VC722VC120 User Manual

Page 2

Advertising
background image

SLOTS

HAND VAC

FILTER

Fig. 2

DUST BOWL

Fig. 3

983000-098

11-02

Fig. 1

DUST BOWL

TABS

DEPRESS RELEASE BUTTON

PULL DUST BOWL

DOWN AND OUT

TO REMOVE

BATTERY

PACK

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions
should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING
HAND VAC

WARNING:

To reduce the risk of fire, electric shock, or injury, read
and understand all instructions in this operator’s
manual and the operator’s manual for the hand vac
before using hand vac, changing attachments, filters,
or making adjustments.

Do not use outdoors or on wet surfaces.

Use only as described in this manual. Use only with

the VC722 or VC120 Hand Vac.

Do not allow to be used as a toy. Close attention is

necessary when used by or near children.

Keep hair, loose clothing , fingers, and all parts of the

body away from openings and moving parts.

A cordless hand vac does not have to be plugged into

an electrical outlet, therefore it is always in operating
condition. Be aware of possible hazards when using
your hand vac or when changing accessories.

DO NOT PLACE BATTERY PACK NEAR FIRE OR

HEAT. The batteries may explode.

SAVE THESE INSTRUCTIONS

REPLACING FILTER

See Figures 1 & 2.

WARNING:

Never use your hand vac without dust bowl and filter
properly in place.

REMOVING DUST BOWL

NOTE: The dust bowl should be checked, emptied and
cleaned periodically to obtain maximum dust collection.

Turn off hand vac and remove battery pack before

changing attachments, filters, or making adjustments.

Depress the release button located on top of hand vac.

Pull dust bowl down and out to separate from motor
housing.

■ Remove the filter by pulling it out of dust bowl
■ Dispose of filter.
■ Empty dust bowl and wash if necessary. Make sure dust

bowl is completely dry before reattaching to hand vac.

■ Insert new filter into dust bowl as shown in Figure 2.

REATTACHING DUST BOWL

See Figure 3.
■ Position the two sections as shown. Align slots on

bottom of dust bowl with tabs on bottom of motor
housing then snap the two sections together.

RYOBI TECHNOLOGIES, INC.

1428 Pearman Dairy Road, Anderson, SC 29625

Post Office Box 1207, Anderson, SC 29622-1207

Phone 1-800-525-2579

www.ryobitools.com

Advertising
This manual is related to the following products: