Operation of icemaker and cold water supply, 1 before using the ice maker and cold water supply, 2 caution – Rangemaster U109100 - 02 User Manual

Page 14

Advertising
background image

14

Only remove the required amount of food from the

refrigerator. Defrosted food cannot be re-stored in
the freezer unless it is fi rst cooked.

Food cut into small portions will freeze faster and

be easier to defrost and cook. The recommended
weight for each portion is less than 2.5kg.

Food should be stored in accordance with any

information printed on the packing.

Do not overload the fridge or freezer. The quantity

of the food in storage should comply with the
cooling capacity of the refrigerator (See the
appliance rating plate).

Operation of icemaker and cold
water supply

1 Before using the ice maker and cold

water supply

Pressure of the cold water supplied to the
automatic ice maker should be between
0.15~0.85Mpa.
The water tube should be cut to the necessary
length and be free from bends. Suggested
maximum length of the water tube is
approximately 12 meters.
The water tube should be away from any heat
source.
Use only drinking water for ice making.
The water tubes should be installed and tested by
professionals.

We recommend that the inline water

filter is changed every 2 years

When the appliance is put into operation for the
fi rst time, keep the Cold Water button pressed for
two minutes to fl ush the system. Never press the
cold water button for an extended period or the
water valve may become excessively warm.

2 Caution:

Before switching the water supply on, ensure that

the ice maker control is set to “OFF”.

Never install the icemaker water tube in an area
with a temperature below 0°C to avoid freezing of
the water tube.
In the installation process, electrical tools must
be properly insulated or wired to avoid electric
hazards.
Turn on the valve to fl ush the water tube and
test water tube joints for leaks. Turn off the valve
when the water becomes clear.
NOTE! - The Icemaker is located inside the
Ice Cube bin. Refer to Page 15 "Removing
and Installing the Ice Cube bin", to access the
Icemaker.

Set the icemaker control to “ON”. The icemaker
will start operation when internal temperature
reaches or is below -13°C. When the appliance is
used for the fi rst time, the ice maker will perform
two ice making cycles and some water may be
discharged into the ice cube bin. This is normal.
Do not use these fi rst loads of ice.


Advertising