Ryobi MS180 - Manual (Page 21)

21
■ Using a 10 mm wrench or adjustable wrench,
loosen the lock nut securing positive stop adjust-
ment screw. Also loosen bevel lock knob.
■ Adjust positive stop adjustment screw to bring
saw blade into alignment with the square.
See Figure 30 .
15
3 0
ADJUSTMENTS
Fig. 29
VIEW OF BLADE NOT SQUARE WITH MITER
TABLE, ADJUSTMENTS ARE REQUIRED
■ If the top or bottom of the saw blade angles away
from the square as shown in figures 28 and 29,
adjustments are needed.
Fig. 28
VIEW OF BLADE NOT SQUARE WITH MITER
TABLE, ADJUSTMENTS ARE REQUIRED
E
Fig. 30
MITER TABLE
POSITIVE
STOP ADJUSTMENT
SCREW FOR 45 ° ANGLES
■ Retighten bevel lock knob. Next, retighten lock nut
securing the positive stop adjustment screw.
Recheck blade-to-table alignment.
Note: The above procedure can be used to check
blade squareness of the saw blade to the miter
table at both 0° and 45° angles.
45
3 0 1 5
0
1 5
22.5
30
4 5
4
5
31 .6 2
22.5 31.62
COMBINATION
SQUARE
FENCE
MITER TABLE
BLADE
45
30 1 5
0
1 5
22.5
30
45
4
5
31.62
22.5 31.62
COMBINATION
SQUARE
FENCE
MITER TABLE
BLADE
POSITIVE STOP
ADJUSTMENT SCREW
FOR 0 ° ANGLES
LOCK NUT(S)