Radio Shack ET-1119 - Manual (Page 15)

15
Each stored number can be up to 20
digits, and each name can be up to 14
characters.
Storing a Name and Number in
Memory
Notes:
• An error tone sounds and the phone
exits the storing process if you wait
more than 20 seconds between
each key press.
• If you receive a call during memory
entry, the phone exits the storing
process.
Follow these steps to store a number in
memory.
1. Lift the handset.
2. Hold down MEM until Memory
Store and a list of memory loca-
tion numbers appears.
3. Choose a memory location ( 1 - 0 ) by
pressing a number or by repeatedly
pressing
or .
4. To store a name, press SELECT .
Store Name appears.
If you do not want to enter a name,
skip to Step 6.
<Memory n> will be
stored as the name ( n is the location
number you selected).
5. To enter a name, use ▲ or ▼ to
select the characters and REDIAL or
FLASH to move the cursor.
Repeatedly press ▼ to view the
characters in alphabetical order.
The display shows uppercase let-
ters first, then lowercase letters,
numbers, and special characters.
Press
▲ to view the characters in
reverse order. You can hold down ▼
or ▲ to scroll rapidly through the
characters.
If you make a mistake, move the
cursor over the error, then enter the
correct character, or press
DELETE
to delete a character. To delete all
the characters, hold down
DELETE
for at least 1 second.
6. Press SELECT . Store Number
appears.
7. Enter the phone number and any
tone or pause entries (see “Using
Tone Services on a Pulse Line” on
Page 14 and “Entering a Pause” on
Page 16).
8. Press SELECT . The phone beeps
and Memory n Stored appears.
After 2 seconds, Memory Store
appears, and you can repeat Steps
3–8 to store more numbers.
9. When you finish, press MEM to exit
Memory Store .
43-1119.fm Page 15 Thursday, September 16, 1999 1:58 PM