Ryobi TS1342L - Manual (Page 13)

13
LOOSE PARTS
WARNING:
The use of attachments or accessories not listed might be hazardous and could cause serious personal injury.
The following items are included with the tool:

Miter Lock Handle
 Dust Bag
 Work Clamp
 Blade Wrench
 Operator’s Manual
Fig. 6
BLADE
WRENCH
MITER
LOCK HANDLE
WORK
CLAMP
DUST BAG
UNPACKING
This product requires assembly.

Carefully lift saw from the carton and the saw base, and
place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 This saw has been shipped with the saw arm secured in
the down position. To release the saw arm, push down
on the top of the saw arm, cut the tie-wrap, and pull out
on the lock pin.
 Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the tie wrap.
ASSEMBLY
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After assem-
bling it, check for accuracy. If shipping has influenced
the settings, refer to specific procedures explained in
this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.