Ryobi BT3100 - Manual (Page 4)

4
UNPACKING
Your new long miter/rip fence kit includes a 41 in. extension
rail, plus the necessary brackets, and connecting hardware
required to assemble a long miter fence and attach it to the
sliding miter table of your BT3000/BT3100/BT3100-1 table
saw. It also includes connectors and hardware required for
attaching a long rip fence to your saw.
Note: When used as a long miter fence this kit temporarily
replaces the miter fence supplied with your saw. When used
as a long rip fence it attaches to the rip fence supplied with
your saw.
Miter/Rip Fence Rail .........................................................1
Bracket (Support and Left Positive Stop)..........................2
Saw Gage.........................................................................2
Knob Bolt .........................................................................1
Knob Nut ..........................................................................1
T-Nut ................................................................................6
Square Head Bolt (1/2 in.)................................................1
5/16 in. Washer.................................................................6
Bracket (Right Positive Stop) ............................................1
Fig. 1
T-NUT
HEX BOLT (1/2 in.) SQUARE HEAD BOLT (1/2 in.)
1/4 in.
WASHER
HEX BOLT
(7/8 in.)
5/16 in.
WASHER
SAW GAGE
CONNECTOR
KNOB BOLT
MITER/RIP FENCE
RAIL
LOCATOR
PIN
PLASTITE SCREW
MITER
INDICATOR
SAW GAGE
WORK SUPPORT
BRACKET
BRACKET (RIGHT
POSITIVE STOP)
BRACKET (SUPPORT AND
LEFT POSITIVE STOP) KNOB NUT
WARNING:
If any parts are missing do not assemble the kit until the
missing parts are replaced. Failure to do so could result
in serious personal injury
LOOSE PARTS
1/4 in. Washer...................................................................1
Plastite Screw...................................................................2
Work Support Bracket ......................................................1
Hex Bolt (7/8 in.)...............................................................1
Miter Indicator...................................................................1
Locator Pin .......................................................................1
Connector.........................................................................2
Hex Bolt (1/2 in.)...............................................................4
 Remove the parts from the box. Make sure that all items
listed in the loose parts list are included.
 Inspect all parts carefully to make sure no breakage or
damage occured during shipping.
 If any parts are damaged or missing, please call 1-800-
525-2579 for assistance.