Remington 498 - Manual (Page 14)

14 114915
4. Place the muzzle of tool perpendicular to work surface without tilting the tool.
Push tool against work surface until sliding action of barrel stops.
Operation
90˚
NOTE:
Failure to start with
the lowest power level
can result in overdrive
condition and will re-
sult in damage to tool
(See page 13).
1. Grasp barrel assembly and slide forward rapidly until it stops. Push barrel assem-
bly back into tool to the closed position. This sets piston into firing position.
3. Select the proper power level of power load strips. ALWAYS insert power load
strips through bottom of handle. Push power load strip in until even with bottom
of handle.
2. Insert power fastener into muzzle of tool, head end first. Push the power fastener
until point is even with end of tool.