First-time operation – RCA ProV600 User Manual

Page 15

Advertising
background image

First-Time Operation

13

Caution

: When a battery is attached to the adapter/charger, do not turn them

upside down. The battery may fall off and be damaged or cause injury.

Charge the Battery

If the DC cable is attached to the DC
OUT
jack on the adapter/charger, remove
its plug.

1. Plug adapter/charger into nearest AC

outlet (100-240V, 50/60Hz). The
POWER indicator lights.

2. Align reference marks on battery with

marks on adapter/charger, and slide the
battery in the direction of the arrow
until it locks into place.

3. If the battery is properly connected,

the adapter/charger’s CHARGE
indicator will light.

Note: The CHARGE indicator will flash

rapidly if the battery is not installed
properly. Remove the battery from the
adapter/charger and attach it again. If the
indicator still flashes, the battery cannot be
charged.

4. When the CHARGE indicator turns

off, remove the charged battery by
sliding it off the adapter/charger.

5. Remove the power cord from the

AC outlet.

Refresh the Battery

The battery will provide increased
operation time if you “refresh” it before
every charging. The refresh feature
“refreshes” the battery by completely
discharging it. Refreshing takes
approximately 4 hours.

1. Plug in the adapter/charger and

attach the battery.

2. Press REFRESH. The CHARGE

indicator flashes slowly while the
battery discharges.

3. When discharging is completed, the

CHARGE indicator stops flashing.
Then the battery begins charging.

4. After the battery is charged, the

CHARGE indicator turn off.

Hold Battery
Flush and
Slide

To AC Wall
Outlet 100-
240 Volts,
50/60 Hz.

CHARGE
Indictor

POWER
Indicator

Adapter/Charger

REFRESH
Button

Reference Marks

Advertising