8 integrated systems, Power for external equipment, Section 6.8 – Raymarine 530 User Manual
Page 133
Chapter 6: Installation
6-17
In
te
gr
at
ed Systems
6.8 Integrated Systems
The displays can be linked to other equipment to transfer data as follows:
•
Data can be received via SeaTalk or NMEA, some of which will increase
the functionality of the display. Other data can be viewed on the display.
•
Data can be transmitted via SeaTalk and NMEA to enhance other equip-
ment.
•
Some incoming data can be converted across the communication link and
re-transmitted - see Data Conversion on page 6-23.
Power for External Equipment
External equipment cannot be powered from the display’s SeaTalk
interface. It must be powered from the ship’s supply or via a SeaTalk bus.
Ensure correct polarity of the SeaTalk connection.
For systems where the ship’s power source is 24 V only, you may need to
install a 24 V to 12 V DC converter. This is only necessary if the products
being connected to the display are:
•
SeaTalk compatible (for example, compass, GPS and instruments), and
there is no existing SeaTalk bus
•
NMEA compatible, but operate only from 12 V (for example, compass,
GPS and some navigators)
The DC~DC converter must conform to the following specification:
Table 6-2:
DC-DC Converter for External Equipment
Input
21 to 32 V DC
Output
13.6 V DC, isolated
Load
Continuous current rating, in excess of required load