Rosewill RNX-N2X - Manual (Page 36)

Wireless Adapter RNX-N2X User Manual
36
• Status: This indicates the state of the client. There are three options:
1. Associated: Indicates that the wireless client is connected to an Access Point (AP). The
BSSID is shown in the form of 12 HEX digits, which is the MAC address of the AP.
2. Scanning: Indicates that the wireless client is searching for an AP in the area.
3. Disconnected: Indicates that there are no APs or clients in the area.
• Extra Info: Displayed here are information about the link stats and the percent of output
power.
• Channel: The operating frequency channel that the client is using (infrastructure mode).
• Authentication: Displays the authentication type.
• Encryption: Displays the encryption type.
• Network Type: Displays the network type; infrastructure or ad-hoc.
• IP Address: Displays the IP address.
• Sub Mask: Displays the subnet mask IP address.
• Default Gateway: Displays the IP address of the default gateway.
• Link Speed: The current rate at which the client is transmitting and receiving.
• Transmit/ReceiveThroughput: Displays the Tx (transmit) and Rx (receive) kilo-bytes per
second.
• Link Quality: In infrastructure mode, this bar displays the transmission quality between an
AP and a client. In Ad-hoc mode, this bar displays the transmission quality between one
client, and another.
• Signal Strength: This bar displays the strength of the signal received from an AP or client.
• Noise Level: Displays the background noise level; a lower level indicates less interference.
• Click on the OK button to close this window.