Raritan Computer MCC4 - Manual (Page 20)

12 M ASTER C ONSOLE II U SER M ANUAL
Installation
Install Base Unit (First-Tier) MasterConsole II
1. Plug the keyboard, monitor, and mouse into the keyboard, monitor, and mouse ports on the
MasterConsole II back panel.
Figure 18 MasterConsole II Rear Panel
Figure 19 Two-Tier Configuration Cabling Detail
2. Power on the MasterConsole II base unit.
3. Connect computers to any Channels on the base MasterConsole II back panel.
a. Shut down and power off all computers to be connected to the base MasterConsole II.
b. Using a Universal cable kit (CCPnnU), plug the 25-pin connector into one of the numbered
Channels on the base MasterConsole II back panel.
c. Plug the cable's other connectors into the computer's keyboard, monitor, and mouse ports. Use
supplied adapters for AT style PCs.
d. Power ON the connected computer.
e. Select the connected computer by pressing the corresponding front panel button. Verify that the
monitor attached to MasterConsole II displays the video for the connected computer. Use the
keyboard and mouse attached to the base MasterConsole II to verify that they operate the
connected computer.
f. Repeat steps 3.a through 3.e to connect additional computers to the base MasterConsole II.
Mouse Port
Keyboard Port Monitor Port