Treme control, Simple serviceability, Temptracker mod – Raypak 1505 User Manual
Page 7: On-board diagnostic center, Diagnostic information
7
X
treme Control
Simple Serviceability
Raypak’s easy-to-understand user interface, including
on-board diagnostics and LED operating status lights,
tells the technician all he needs to know. All
service/repair components are readily accessible from
the front or side for maximum installation flexibility.
To enhance serviceability, the control box is completely
removable allowing total access.
TempTracker Mod
Raypak’s XTherm comes standard with TempTracker Mod. This control can be used for
space heating and hot water supply with 8 application-specific modes to meet various
applications, including outdoor reset for heating systems. The control monitors and dis-
plays inlet and outlet temperatures on all applications as well as monitor outdoor tem-
perature when an outdoor reset mode is selected. Only Raypak’s TempTracker Mod
allows for a user definable outdoor reset ratio. Adjustable limits prevent over-cycling,
saving energy and extending the life of the heater. Your XTherm is never down with a
sensor failure thanks to Raypak’s exclusive TempTracker software. It can operate with as
little as one functioning sensor, keeping you up and running until service arrives.
•
P or PID logic
•
0-10VDC Setpoint Input
•
0-10VDC Direct Drive Input
•
4-20ma output
•
Building management direct control
•
LCD Display
•
Freeze Protection
On-Board Diagnostic Center
Raypak’s XTherm comes equipped with a microprocessor-controlled diagnostic control center that displays its information on a
2x20 character LCD display in plain English. This control monitors system safeties, ignition faults and system status, while storing
up to 16 reported faults. Raypaks diagnostic center monitors the fault outputs of the Fenwal ignition control. Converting the
Fenwal’s flashing lights into real English fault codes that anyone can understand. The control is also equipped with a SPDT dry
contact relay output that is switched anytime a safety fault occurs. This can be used for a heater alarm or a BMS safety interface.
Example Diagnostic Fault Report
Diagnostic Information
Safety Faults
Ignition Control Faults
•
Condensate Drain
•
Low Air
•
Manual High Limit
•
Flame- No CFH
•
Auto High Limit
•
Ignition Lockout
•
Low Water Cut-off
•
Low HSI Current
•
Vent Pressure
•
Low 24VAC
•
High Gas Pressure
•
Internal Control Fault
•
Low Gas Pressure
•
Controller Alarm
•
Flow Switch
•
Blower Switch
•
Factory Option
•
External Interlock
•
Cold Water Run
Water Flow Sw Fault
Check Boiler Pump, Purge Air, Replace Flow Switch