Things to consider before connecting components, Chapter 1: connections & setup, Protect components from power surges – RCA VR648HF User Manual
Page 5: Position cables to avoid audio hum or interference, Protect components from overheating
Chapter 1: Connections & Setup
Chapter 1
3
Things to Consider Before Connecting Components
Protect Components From Power Surges
•
Connect all components before plugging any power cords into the wall outlet.
•
Always turn off the TV and other components before you connect or disconnect any cables.
Position Cables to Avoid Audio Hum or Interference
•
Insert all cable plugs firmly into their jacks.
•
Place any Audio/Video (A/V) cables to the side(s) of the TV’s back panel instead of straight down the back after
connecting components.
•
Try not to coil any twin-lead cables and keep them away from all A/V cables as much as possible.
•
Make sure all antennas and cables are properly grounded. Refer to the Safety Tips sheet packed with your unit for
detailed information.
Protect Components From Overheating
•
Never block ventilation slots in any component. Arrange the components so that air can circulate freely.
•
Do not stack components.
•
Allow adequate ventilation when placing components in a stand.
•
Place an amplifier or satellite receiver on the top shelf of a stand so heated air rising from it will not flow around
other components.