RoyalTek RBT-1000 - Manual (Page 27)

22
Figure 1
5.2.5. Auto Scan
Automatically scans the BT GPS mini COM Port and baud rate in order
to connect BT GPS mini device.
5.2.6. Factory Reset:
Factory reset to the device. To reset all parameters and to disconnect
Bluetooth.
5.2.7. Disconnect
Disconnect to the BT GPS mini device.
Note:
When perform Auto Scan, user has to wait for a while because it will take time
to get necessary system information from BT GPS mini.
5.3. Navigation Page
You can set GPS-relative parameters by this dialog.
5.3.1. NMEA Mode / SiRF Mode
Display (or change) the mode of device.
Setup the parameters of NMEA Mode or SiRF Mode.