Radio Shack PRO-79 - Manual (Page 32)

32
2. Press MON/CL . M , a monitor memory number, and CH flash,
and the frequency in the selected monitor memory appears.
3. Enter the desired monitor memory’s number (1–20), then
press MON/CL again. The selected monitor memory’s fre-
quency appears.
4. Press ENT . The scanner stores the frequency in the selected
channel.
5. To move another monitor memory frequency to the next
channel, press PGM and repeat Steps 2–4.
SCANNING THE STORED CHANNELS
To set the scanner to continuously scan through all channels
with stored frequencies, simply press
SCAN . SCAN and ▲ ap-
pear, and the scanner begins to rapidly scan until it finds an ac-
tive frequency.
When the scanner finds an active frequency, it stops and dis-
plays that channel and frequency number, then it automatically
begins scanning again when the transmission on that frequency
ends.
Notes:
• To reverse the scanning direction, press ▲ or ▼ .
• To set the scanner to remain on the current channel for 2
seconds after the transmission ends, see “Delay” on
Page 36.
• To set the scanner to remain on the current channel, even
after the transmission stops, press MAN at any time during
the transmission so MAN appears and SCAN disappears
(see “Monitoring a Stored Channel” on Page 33).
• To lock out channels so the scanner does not stop for a
transmission on those channels, see “Locking Out Channels
or Frequencies” on Page 36.
20-314.fm Page 32 Monday, December 13, 1999 12:55 PM