Rosewill RC-302 - Manual (Page 4)

1 ports Parallel PCI Adapter RC302 User Manual
5
5. at the “Browse” option, select
“CD-ROM(D)
FOLDER “PCI_I/O\NM97X5\WIN9X”
“OK” button
6. The “Update Device Driver Wizard” will
appear, informing you that it has found
the “NetMos PCI I/O Card” driver. Click
the “Next” button.
.
7. Follow the instructions to finish up the
drive installation.
.
8. Once Windows 9x has restarted, you
can now connect your external devices
to the PCI I/O card install the driver for
the external devices, please refer to the
external device user manual.
.
Windows NT 4.0
Using the existing hard disk controller in your system, you need to install the ATA/100 driver into Windows NT first.
Without ATA/100 driver support, hard drive attached to the ATA/100 IDE controller card can not boot up Windows NT.
Installing drivers with existing Windows NT 4.0:
Make sure Windows NT 4.0 is properly installed into your system first.
Step 1: Start Windows NT 4.0.
Step 2: Insert Driver CD into the CD-ROM drive.
Step 3: Select “Run” option in Windows NT.
Step 4: At the “Run” option, click on the “Browse” button.
Step 5: At the Browse for Folder window:
1. Select “CD-ROM Drive (D)”
2. Select NetMosMultiIODrivers.exe