Roller Derby 1687284 - Manual (Page 3)

3
40” Roller Bar Mower Kit
Installation Instructions
Install Roller Shaft Assembly
1. Attach the roller bar assembly (A, Figure 4) to the left
side of the rocker shaft assembly (B) using a
3/8-16 x 2-1/2 capscrew (C), adjusting nut (D),
spacer (E), and 3/8-16 security locknut (F). Once
roller bar assembly has been properly adjusted,
tighten nut to 40 ft lbs. (54 Nm)
A
B
C
D
E
F
Figure 4. Install Roller Shaft Assembly
A. Roller Shaft Assembly
B. Rocker Shaft Assembly
C. Capsrew, 3/8-16 x 2-1/2
D. Adjusting nut
E. Spacer
F. Nut, lock, flanged 3/8-16
2. Attach the roller bar assembly (A, Figure 5) to the left
side of the mower deck (B) using a 5/16-18 x 1-1/4
capscrew (C), 5/16 flat washer (D), spacer (E), and
5/16-18 flange locknut (F). Tighten nut to 11 ft. lbs.
(15 Nm)
Figure 5. Attach Roller Bar to Mower Deck Left Side
A. Roller Bar Assembly
B. Mower deck
C. Capscrew, 5/16-18 x 1-1/4
D. Washer, flat, 5/16
E. Spacer
F. Nut, lock, flanged, 5/16-18
A
B
C
D
E
F
3. Attach the roller bar assembly (A, Figure 6) to the
right side of the mower deck (B) using two 5/16-18 x
1-1/4 capscrews (C), two flat washers (D), tow spac-
ers, and two 5/16-18 flanged locknuts (E) as shown.
Tighten nuts to 11 ft. lbs. (15 Nm)
Figure 6. Attach Roller Bar to Mower Deck Right
Side
A. Roller Bar Assembly
B. Mower deck
C. Capscrews, 5/16-18 x 1-1/4
D. Washers, flat, 5/16
E. Spacers
F. Nuts, lock, flanged, 5/16-18
A
B
C
D
D
E
F